There comes a time when the damage that is on your water heater is beyond repair. In such a situation, it makes more economic sense to install a new water heater instead of trying to repair the existing one. You will discover that its time to install a new water heater when the old one keeps going bad. The other instance is when the cost of repair is close to that of buying a new one. You need to make your calculations well and take a move that makes a lot of economic sense. You can also go for a water heater installation when you are dealing with a new building.
There are two approaches to water heater installation. You can either decide to do it yourself or hire the services of a professional handle the project on your behalf. The DIY is cost-effective but you should not try it unless you have the required skills. Wrong installations may end up being very costly in the long run. You may damage the equipment and end up buying a completely new set.
It is a wise move to employ the services of a plumber to assist with the installation work. You will be sure that the work will be done right during the very first attempt. These professionals are highly experienced and they don’t use any guesswork at all. You will pay them some fee but it will save you a lot of trouble in the long run.
The water heater installation process is a pretty simple one and you can perform it by yourself. The most important thing is to make sure that you are comfortable with the DIY procedure. In this article, we will be going through the simple steps of water heater installation. You will discover that the installation process is quite simple as long as you have some basics. Let us go through the installation process to get a rough idea of what is expected of you.
Switch the Water Connection off
Its advisable to shut the water connection off before you embark on the installation process. Shut off the line that is on the water line that leads towards the water heater. You should also make sure that the gas line is off and also turn the knob off. Make sure the knob is in a perpendicular position with the knob. In case you are dealing with an electric connection, make sure you plug off the old heater.
Connect a Hose
The next thing you need to do is to connect the hose to the drain valve that is located close to the heater. Make sure the hose is placed close to an outside location. Open the drain valve to allow the water to drain out.
Unscrew the Inlet of Water
The next step is to unscrew the inlet of the water and the fitting for the water outflow. It is normally located at the top section of the heater. It is advisable to utilize a pipe wretch when doing this task. You also need to unscrew the gas line fitting.
Remove the Old Heater
At this stage, you will have to remove the old heater and throw it according to the governing rules and regulations. Install the new heater in the place you removed the old one and level it appropriately. Make sure that all the controls can be accessed with ease.
Screw the Water Inlet and Outlet Line
Screw on both the outlet and inlet line with the aid of the wrench. You can now open the water line and fill the tank completely.
Connect Your Gas Line
Use the wrenches to connect the gas line. In case you are dealing with an electric heater, you will be expected to switch on the mains. It’s a wise move to seek professional guidance in case you are new to this task.
Here is a list of our services you can get at The Water Heater Guy:
FOR MORE INFO, CALL OR TEXT ANY OF OUR NUMBERS
Phone & Address
Lee & Collier: 239-243-8537
3343 Fowler St.
Fort Myers FL 33901
SHARE THIS PAGE!